Apply Settings For A Pc - Pioneer KURO KRP-600M Mode D'emploi

Use Other Equipment With Your Flat Panel Display
6.2.2

Apply Settings for a PC

Connecting a PC to your flat panel display requires specific settings. This section also explores the basic screen
adjustments on the flat panel display after applying initial settings for the PC.
1 ) Access INPUT 3(D-Sub15) through the Input Setup menu.
2 ) Select the desired item.
D-sub15, Blu-Ray, DVD, DVR, VCR, Cable, Satellite, GAME or Computer for Input Name; RGB, Comp.1
(YCbCr) or Comp.2 (YPbPr) for Color Decoding. Auto is only available for Signal Format.
3 ) Press EXIT to exit the menu.
When connected to a PC, your flat panel display automatically identifies the input signal type. If the panel fails to
see the PC or the picture is unclear, use the Screen function to adjust the image.
Automatic Image Position and Clock Adjustments
When connected to a PC, the image position, clock phase and clock frequency can be adjusted. The Auto Setup
option automatically adjusts these settings but the image position and clock can be adjusted manually too. This
section covers the automatic setup function and the following section explains how to manually adjust positions
and clock.
The AV source device must be connected to the flat panel display and turned on for this option to work. To activate
Auto Setup, follow the directions below.
1 ) Access Auto Setup through the Screen menu.
The function begins as soon as the selection is made. However, depending on the image, the position may
not change after adjustment.
2 ) Press HOME MENU to exit the menu.
Note: This function is unavailable when the PC is connected through the HDMI terminal.
When Auto Setup finishes, the message "Auto Setup Completed" appears on screen. However, if the setup fails
to adjust the image, the message still appears if other factors affect the change. Auto Setup may fail with a PC
image composed of similar patterns or a monochrome picture. If Auto Setup fails to correct the image positioning
and clock, change the PC image and try again.
Manual Image Position and Clock Adjustments
Usually Auto Setup for a PC is the best practice for adjusting the image position, clock phase and clock frequency.
However, to personally optimize the screen, follow the directions below.
1 ) Access H.Position, V.Position, Clock or Phase through the Screen menu.
H.Position
V.Position
Clock
Phase
2 ) Use the up/down arrow buttons (/) to adjust the option.
H.Position, V.Position, Clock and Phase also accept the left/right arrows (
3 ) Press HOME MENU to exit the menu.
Option
adjusts the horizontal position of an image
adjusts the vertical position of an image
adjusts an image when jitter appears
adjusts an image when jittered or low-contrast
characters, etc. appear
Description
/
) for changes.
06
57
En