Pioneer KURO KRP-600M Mode D'emploi page 76

Use Other Equipment With Your Flat Panel Display
06
Monotone Mode
Monotone Mode cuts the video signal's color components so that images appear using only luminance signals.
Notes: This setting applies to each input source.
Entering Studio Mode, AV Selection or Picture Preset is unavailable while in Monotone Mode.
Drive Mode
This option optimizes the picture quality depending on the content (refer to "5.3.10 Adjust Color Signals" for more
information).
Note: Drive Mode is available only for input video signals.
FRC Mode
The FRC option allows switching the frame rate conversion.
Note: FRC Mode is available only for input PC signals.
Fan Control
This option switches the control method for the rear cooling fan of the flat panel display.
The Max setting is effective for special high-temperature installations. However, since the fan noise increases, the
effect on the surrounding area should be taken into consideration.
76
En
Parameter
On switches to the Monotone Mode
Off* No effect
Parameter
Default* does not switch the frame rate conversion
Sync switches the frame rate conversion
Parameter
Auto* automatically controls using an internal
temperature sensor
Max for maximum rpm (Auto Control: Off)
Description
*Factory default
Description
*Factory default
Description
*Factory default