Use Other Equipment With Your Flat Panel Display; Program The Remote Control To Operate Other Equipment; Use The Learning Function - Pioneer KURO KRP-600M Mode D'emploi

Use Other Equipment With Your Flat Panel Display

06
6 Use Other Equipment With Your Flat Panel
Display
Although earlier sections have mentioned other equipment for playing back video, this section provides control
and operation information for specific types of equipment.

6.1 Program the Remote Control to Operate Other Equipment

To operate other equipment or devices through your flat panel display, program the panel's remote control with
the equipment's manufacturing code. A manufacturing code is a series of numbers that identify the type of device
and the brand. These codes are available in the section entitled "Manufacturer Codes to Program into the Remote
Control" in Appendix 9.1 of this manual.
6.1.1

Use the Learning Function

The Learning function allows the panel's remote control to memorize codes
to control other devices.
To set the Learning function to On, follow the directions below.
1 ) Press SELECT to choose the other device.
2 ) Simultaneously press the EDIT/LEARN and 2 buttons to begin.
The selected mode indicator flashes when the remote control is ready
to be programmed.
3 ) Use the number buttons to learn a manufacturing code.
The mode indicator lights up.
The Learn session is canceled in 30 seconds and the indicator begins
blinking again. When the indicator flashes, the selected device's
remote is memorized.
When you press a button that cannot be learned, the indicator
continues to blink.
To exit the Learn mode before it finishes, press
4 ) Press EDIT/LEARN again to exit the Lean mode after the code is confirmed.
:
Notes: The Learn session cancels if:
• no operation is performed for more than one
minute after having pressed
(the mode indicator is flashing)
• you press
Code transmission finishes in approximately two
seconds. Do not interrupt the process until the
transmission is complete.
When using any of the receiver buttons
(a, INPUT
code remains the same.
50
En
EDIT/LEARN
SELECT
, or , the learned manufacturer
VOL+/–)
EDIT/LEARN.
and 2
Remote control
(Supplied accessory)
1 2 3 4
5 6 7 8
SUB PIP
INPUT
SELECT
BDP EDIT/LEARN
MONITOR STB LD VCR
CBL DVD
SAT DVR
2 cm to 5 cm
(0.8 inches to 2.0 inches)
Remote control of
AV product