RAMSEY WINCH H-89 Manuel D'utilisation, D'entretien Et De Maintenance page 16

FIGURE 8
If shaft and/or gear is damaged, replace as
27
follows:
19
a. Tap keys #27 into short keyways of drum shaft #32.
32
b. Press shaft #32 and keys through gear hub #19 until
end of keys on long end of shaft are flush with gear.
27
FIGURE 8
FIGURE 9
Check gear housing bushing #10 and o-ring #86 for signs
of wear. Replace if necessary by pressing old bushing from
gear housing #22. Press new bushing into place and insert
new o-ring #86 into groove inside of bushing.
FIGURE 10
Check drum bushings #41 & #42 for signs of wear.
Replace if necessary by pressing old bushings from drum
#18. Press bushing #41 into bore in drum until flange is
seated against bottom of counterbore. Press bushing #42
into opposite bore on drum until end of bushing extends .50"
from end of drum.
FIGURE 11
Check end bearing bushing #42 for signs of wear. If
necessary, remove old bushing and press new bushing into
place.
FIGURE 12
Check cover bushing #10 and o-ring #86 for signs of
wear. Replace if necessary by pressing old bushing from
gear housing cover #16. Press new bushing into place and
insert new oring #86 into groove inside of bushing.
16