Install The Operator; Assemble The Transmission And Drive Arms - CAME FE4024 Instructions D'installation

INSTALLATION

INSTALL THE OPERATOR

The following steps are for a right hand installation. For a left hand installation the
operator is installed upside down.
1
Insert the side supports into the pillar bracket. One side support is for the
power cable, the other side support is for the transmission arm (Figure 1).
2
Insert a watertight connector into the hole on the side support for the power
cable as shown (Figure 1).
3
Slide the operator onto the pillar bracket (Figure 2).
4
Secure the operator to the pillar bracket with the provided hardware
(Figure 3).
5
Place the manual release lever on the release shaft and secure with screw and
washer (Figure 4). The illustration shows a left-hand installation, a right-hand
installation will look slightly different.
6
Release the operator by turning the release lever clockwise.
Figure 2

ASSEMBLE THE TRANSMISSION AND DRIVE ARMS

1
Insert the plastic spacer onto the transmission arm (Figure 1).
2
Insert the transmission arm into the motor shaft and secure with the provided
washer and screw (Figure 1).
3
Attach the drive arm to the transmission arm using the provided washer and
screw (Figure 2).
4
Attach the drive arm to the gate bracket using the provided nut and bolt
(Figure 3).
Figure 1
Transmission Arm
Plastic Spacer
Figure 1
Figure 3
Screws
Nuts
Figure 2
12
INSTALL THE OPERATOR + INSTALL THE OPERATOR ARM
Figure 4
Figure 3
Drive Arm
Side Support - Transmission Arm
Side Support - Power Cable
Watertight Connector
Release Shaft
Manual Release Lever