Attach Handle to the Pressure
Washer
Use either a 13mm or adjustable wrench to attach the
handle to the pressure washer.
To attach handle to the pressure washer:
1.
Slowly tip pressure washer forward and let it gently
rest on front bumper.
2.
Align holes on handle with holes on base.
3.
Insert carriage bolts provided to hold handle in place
(Figure 2).
Figure 2 — Attach Handle to Pressure Washer
4.
Secure handle to pressure washer using four provided
flange nuts.
5.
Slowly tip pressure washer back in place and insert
multi–colored spray tips in spaces provided in handle.
3400 PSI Pressure Washer
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1.
Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 3). Pull back
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of a tight
connection.
7
CAUTION