What To Do In Case Of A Problem - Pando PI 3100 Manuel D'utilisation

INOXPAN S.L.

WHAT TO DO IN CASE OF A PROBLEM

The hob or the cooking zone doesn't start-up :
• The hob is badly connected on the electrical network.
• The protection fuse cut-off.
• The looking function is activated.
• The sensitive keys are covered of grease or water.
• An object is put on a key.
The control panel displays [ U ]:
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The control panel displays [ E ] :
• Call the After-sales Service.
The control panel displays [ L ] :
• Refer to the chapter control panel locking page.
One or all cooking zone cut-off :
• The safety system functioned.
• You forgot to cut-off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of power level and breaking Automatic
overheating
Continuous ventilation after cutting off the hob :
• This is not a failure, the fan continuous to protect the electronic device.
• The fan cooling stops automatically.
The automatic cooking system doesn't start-up :
• The cooking zone is still hot [ H ].
• The highest power level is set [ 9 ].
The control panel displays [ U ] :
• Refer to the chapter "Keep warm".
The control panel displays [ II ]:
• Refer to the chapter "Pause ".
The control panel displays [ ∏ ]:
• Refer to the chapter "Bridge".
When the symbol [ E 4 ] appears :
• The table must be reconfigured by following the following steps :
I) Important : before you start, make sure there is no more pot on the hob
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit
breaker off
III) Reconnect the table to the grid
IV) Procedure :
* take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after connecting the hob to the grid
88