Operating Instructions; Switching On And Off; Keyboard Description; Led Indicators - Sammic WATERBATH Serie Mode D'emploi

Operating Instructions

Sw it ch in g ON a n d OFF: Switching ON - the unit may be turned ON (I) at the mains switch
located a t t h e r ea r . When ON (I) the switch is illuminated and unit performs a self test
where all segments of the 3 digit LED display and indictors illuminate.
Switching OFF: the unit may be turned OFF(O) at the mains switch located at the rear. All
current temperature and time values remain in memory.

Keyboard Description

LED Indicators

HEATING INDICATOR
When LED is illuminated bath is being heated.
TIMER INDICATOR
- Flashing illumination indicates timer is running back/counting
down.
SET TEMPERATURE INDICATOR
- Continous illumination indicates set point is shown on display.
The circulator features a low liquid level protection system.
"FILL"
If the liquid level drops below the predetermined point the heating and
stirring will cease and display will flash between "FILL" and actual tank
or pot temperature. To clear message and resume heating refill the
tank or pot then switch the unit OFF and back ON.
FUNCTION
- Press once "SP1" is displayed.
- Press twice "t" is displayed, timer setting.
DOWN ARROW
- Used to decrease a value. Hold continously to scroll.
- When pressed for more than 1.5 seconds, "SP1" is
displayed.
UP ARROW
- Used to increase a value. Hold continously to scroll.
RUN
- When pressed for more than 1.5 seconds will activate/
deactivate timer function.
- Used to turn off buzzer.
7