Setting The Cutting Height; Battery; Maintenance - AL-KO Robolinho 100 Traduction Du Mode D'emploi D'origine

Mowing tips
If the motor speed drops noticeably because
of thick grass, increase the cutting height and
mow in several passes.
ADVICE
To allow the performance of the
Robolinho to be exploited to the full, we
recommend having the automatic lawn-
mower mow the lawn during cool times
of the day or at night.
DANGER!
Danger of injury due to the cutting bla-
des!
Before all maintenance and care
jobs, always switch off the automatic
lawnmower using the [ON/OFF key].
Disconnect the transformer of the
base station from the mains.
Always wear work gloves when per-
forming maintenance and care jobs
on rotating and/or cutting tools!

SETTING THE CUTTING HEIGHT

Opening the cover
Pull item (2-6).
Setting the cutting height (10)
1 Open the lever up and turn it a quarter turn
clockwise in the direction of [lock symbol
opened].
The cutting height adjustment is unlo-
cked.
2 Pull the lever upwards.
Lawn cutting height is increased.
3 Push the lever downwards.
Lawn cutting height is reduced.
4 Then turn the lever a quarter turn anticlock-
wise in the direction of [lock symbol closed]
and engage.
Cutting height adjustment is locked.
5 Fold the lever down and close the cover (2-6).
ADVICE
The cutting height varies in the range
from 3 - 6 cm lawn height. It can be ad-
justed in five steps of 6 mm each.

BATTERY

The integrated battery is partially charged on
delivery. During normal operation, the battery
of the Robolinho is regularly recharged.
440339_a
When the battery charge reaches 0%, the
Robolinho automatically returns to its base
station in order to charge the battery.
Interrupting charging does not damage
the battery.
The base station is equipped with an elec-
tronic control unit with a monitoring function.
This automatically terminates the charging
procedure when a 100% charge status is re-
ached.
The battery status is shown on the display.
Make sure the charging contacts (11-1) of the
base station have adequate contact with the
contact surfaces (11-2) on the Robolinho.
The temperature range for charging should
be between 0 and 40 °C.
The built in protection circuit prevents the
battery from being charged at temperatures
above 45 °C, in order to prevent irreparable
damage to the battery.
If the operating time of the battery is reduced
in spite of it being fully charged, have the bat-
tery replaced by a new genuine battery. This
task should be carried out by an AL-KO dea-
ler, technician or service partner.
If the battery charge level has dropped be-
low the threshold set by the manufacturer as
a result of ageing or excessively long storage,
this means it cannot be recharged any longer.
Have the battery and the monitoring electro-
nic control unit checked by an AL-KO dealer,
technician or service partner, and renew it if
necessary.
The battery status is shown on the display.
Check the battery status after about 3 months
by switching on the Robolinho and reading off
the battery status. If necessary, place it in the
base station for charging.
ADVICE
The battery has been tested according
to the UN handbook. Therefore, it is not
subject to national and international re-
gulations governing substances of con-
cern, whether it is an individual part or
has been installed in the machine.

MAINTENANCE

Regularly check the Robolinho and the base
station for damage
Have damaged parts and batteries replaced
or repaired by an AL-KO dealer, technician or
service partner
31