Adjusting The Handlebar To The Body Size (06); Setting The Working Depth (07); Establishing The Mains Connection (08); Starting And Stopping The Motor (09) - AL-KO COMBI-CARE 36 E comfort Mode D'emploi

GB
Folding out the handlebar
Proceed in reverse order.
6.2 Adjusting the handlebar to the body
size (06)
1. Loosen the quick release on the rotary/snap-
in joints (06/1).
2. Turn the handlebar to the desired height
(pos. a) at the handle (06/2). The rotary
movement is limited by the end stops (06/3)
of the rotary/snap-in joint.
3. Tighten the quick releases (06/1).
6.3 Setting the working depth (07)
The setting of the working depth depends on:
■
Grass condition (well-kept: low working
depth, overgrown: large working depth)
■
Blade wear (new: low working depth, worn:
large working depth)
If the working depth is too large: The appliance
stands still and the motor does not run.
IMPORTANT!
Danger of damage to the
appliance
Setting the working depth
with the appliance running
causes damage.
■
Only set the working
depth when the motor
and blade system have
stopped.
1. Turn the adjuster wheel (07/1) to HIGH, i.e.
level 1 on the working depth indicator (07/2).
The blade system is raised to the maximum.
2. Checking the working depth:
■
Start the appliance (see chapter 6.5

"Starting and stopping the motor (09)",

page 24).
■
Move a little way onto the grass and
check the result. If the grass is too short
or irregularly scarified, the blade system
must be lowered.
3. Stop the appliance and wait until the blade
system has stopped.
24
4. Turn the adjuster wheel (07/1) a little towards
LOW, i.e. levels 2 to 5. The blade system is
lowered.
5. Repeat the previous steps until the grass is
uniformly scarified.
6.4

Establishing the mains connection (08)

1. Firmly plug the socket (08/1) of the mains
cable into the plug (08/2) on the motor
switch.
2. Clamp the mains cable (08/3) in the cable
strain relief (08/4) (pos. a, pos. b) so it cannot
be pulled off the motor switch.
6.5 Starting and stopping the motor (09)
IMPORTANT!
Danger of damage to the
appliance
The motor and blade sys-
tem can be damaged by
consecutively switching on
and off briefly several
times.
■
Only switch the motor
on when the blade sys-
tem has stopped.
Starting the motor
1. Press and hold the safety push switch (09/1)
(pos. a).
2. Pull the motor switch bracket (09/2) to the
handlebar (09/3) (pos. b). The motor and
blade system are started.
3. Release the safety push switch (09/1) and
hold the motor switch bracket (09/2).
NOTE
The motor switch bracket does not lock
in place. Hold it tight against the handle-
bar during the entire working period.
Stopping the motor
1. Release the motor switch bracket (09/2). It
automatically returns to the initial position
(pos. c).
The motor stops immediately. The blade system
keeps running until it stops.
Operation
COMBI-CARE 36 E comfort