Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1.
Fit the top baffle under the top panel of the
appliance case. Secure with 2 thread forming
screws.
2.
Fit the stand-off spacers. The stand-off spacers
for these installations are supplied flat. These
spacers are left and right handed.
! Warning: Failure to install the stand-off
spacers may result in a fire hazard.
a)
Remove the screws near each of the rear
top corners of the appliance and the screws
near the rear top of each side.
b)
Bend the spacers as shown.
c)
Screw the spacers to the rear of the appliance
using the screws just removed.
d)
Bend the side wings of the spacers to align
the holes in each spacer with those in the
appliance sides. Secure the spacers using the
screws just removed.
6
3.
Mount the framing plate to the appliance.
Secure the framing
plate and brackets
to the sides of the
appliance case with
4 thread cutting
screws supplied.
Screw from the
outside through the
access holes in the
framing plate.
Note: There are
alternate methods
of finishing around
the framing
plate—either
leaving it exposed
or recessing it and
covering it up with
the wall finish. See
page 4.
4.
Install plinth and rear base support below
firebox (optional).
The purpose of the plinth is to allow the
appliance to be placed on a rough subfloor,
such as plywood, without regard for the
additional thickness of floor finishes as the
appliance bottom must otherwise be placed at
the finished hearth height or the front trims will
not fit on the appliance properly.
a)
Detach the burner module from the
Publicité
Table des Matières
