Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Framing when installing
larger 1365 or 1370 Surrounds
This Addendum covers specifi c information regarding the installation of Vogue Series
fi replaces to be installed with the larger 1365 or 1370 surrounds.
IMPORTANT: The information contained in this Addendum must be used in
conjunction with the installation manual provided with the fi replace AND takes
precedence over the information provided in the installation manual.
READ VERY CAREFULLY BEFORE YOU START THE INSTALLATION!
Disregard this Addendum if using plates, trims, and surrounds other than 1365 and
1370 surrounds.
2-3/4"
Base of appliance
(70 mm)
behind trim
44-3/4" (1137 mm)
190 – 2255 Dollarton Highway, North Vancouver B.C., CANADA V7H 3B1
4001746-ADDENDUM
©2009, Miles Industries Ltd.
All manuals and user guides at all-guides.com
V
OGUE
Vogue Series
Installation Addendum
Miles Industries Ltd.
Tel. 604-984-3496 Fax 604-984-0246
www.valorfi replaces.com
- A
DDENDUM
• The larger perimeter of 1365/1370 surrounds allow
for non-combustible wall fi nishes such as tile to run
behind the surround.
• This 1365/1370 surround installation also allows
the surround plate to "fl oat" 1/2 inch (13 mm) off the
fi nished wall.
See instructions packaged with the 1365 or 1370 for
surround installation.
July 2009
Publicité
Manuels Connexes pour Miles Industries Valor Serie
Sommaire des Matières pour Miles Industries Valor Serie
- Page 1 See instructions packaged with the 1365 or 1370 for surround installation. 44-3/4” (1137 mm) Miles Industries Ltd. 190 – 2255 Dollarton Highway, North Vancouver B.C., CANADA V7H 3B1 Tel. 604-984-3496 Fax 604-984-0246 www.valorfi replaces.com 4001746-ADDENDUM ©2009, Miles Industries Ltd.
- Page 2 All manuals and user guides at all-guides.com Framing & Hearth Requirements Framing Dimensions (when installing 1365 and 1370 Surrounds) Between underside 1/2” thick cement board required above of header and bottom of firebox Min. 2-3/4” if using #1365 or #1370 Four-Sided Combustible framing allowed Surrounds...
- Page 3 All manuals and user guides at all-guides.com Appliance Preparation Fitting the appliance into framing Fixing the appliance to the framing Recess the appliance in the framing in accordance with 1. Remove the front bottom overlay panel by removing the wall finish details as shown below. 2 screws on each side and slide the panel out from under the firebox.
- Page 4 (70 mm) behind trim Consultez les directives d’installation fournies avec les bordures. 44-3/4” (1137 mm) Miles Industries Ltd. 190 – 2255 Dollarton Highway, North Vancouver C.-B., CANADA V7H 3B1 Tél. : 604-984-3496 Téléc. : 604-984-0246 www.foyervalor.com...
- Page 5 All manuals and user guides at all-guides.com Encastrement Dimensions d’encastrement (lorsque l’installation comprend une bordure 1365 ou 1370) Panneau en béton de 1/2 po (13 mm) d’épaisseur exigé au-dessus du foyer Entre le dessous de la poutre de tête et la base du foyer.
- Page 6 All manuals and user guides at all-guides.com Préparation de l’appareil Encastrement de l’appareil Fixation de l’appareil à la charpente Encastrez l’appareil selon le type de finition du mur tel 1. Enlevez la plaque de seuil en dévissant les 2 vis de qu’indiqué...