Washing And Drying The Filters - Dyson 360 Heurist Mode D'emploi

Maintaining your
robot's performance
Follow a few regular, simple maintenance steps.

Washing and drying the filters

Wash filters with cold water at least once every month.
To remove the
pre-motor filter:
Press the bin release
button and remove the
filter behind the bin.
To remove the
post-motor filter:
Press the button on the
filter cover and remove.
Pull the filter from the
robot.
10
08.11.2018 10:25 - C91389_RB02_OPMAN_CA_X276-OPMAN-91389.indd_15_4c0s
Wash the filters with cold
water, repeat until the
water runs clear.
Tap to remove excess
water and leave to dry
for at least 24 hours.
Ensure that the filters are
completely dry before
refitting.
To refit the
pre-motor filter:
Push the filter back into
position and refit the
clear bin.
To refit the
post-motor filter:
Push the filter back
into position and refit
the filter cover.