Pre-Assembly And Installation Planning - Honeywell MILLER SkyORB Manuel D'utilisation

Possible Connection Heights
(from Ground Level to SRL Anchor Point)
240 in. (20') - (6.1m) - Pin in top position
228 in. (19') - (5.8m)
216 in. (18') - (5.5m)
204 in. (17') - (5.2m)
192 in. (16') - (4.9m)
180 in. (15') - (4.6m) - Lowest pin position
168 in. (14') - (4.3m) - Pin removed
(unit may be harder to turn without pin)
ALWAYS calculate fall clearance required based on the connection
height (from the work platform to the SRL anchor point) being used.
Connection heights are approximate and may be slightly different in
reality due to cable and shock absorber length differences. Please
allow at least 6 in. (152.4mm) above these values for overhead
clearance. Always check for clearance before moving through
passageways to avoid damage to the unit or possible tipping. The
boom can be lowered (by disconnecting the cable) to provide over-
head clearance of 40 in. (1.02m) less than above values (making
the unit height 46 in. (1.12m) less than normal height).

4.0 Pre-Assembly and Installation Planning

Inspection and Maintenance).
and properly assembled. All fasteners and connectors must be checked for correct alignment and installation and tightened to required
approved by Honeywell Safety Products. Lock washers must not be reused; replace lock washers each time a bolt assembly must be
instructions provided with the fasteners.
resist strength degradation caused by rust.
sonal fall arrest system.
ments and/or procedures.
Us e r I nst r uct i o n s - E ng l i sh
Materials
General Construction:
Steel Components:
Load Bearing Hardware:
Other Components:
Cable Assembly:
Technical
Max. Capacity:
Design Factor:
Max. Work Radius:
Proof Load:
Compliance
Meets OSHA 1926.502M
7
Welded Steel
1026 Alloy; A36 Alloy;
Zinc Primer and Powder Coat
Zinc-Plated Steel (grade 8);
Stainless Steel (18-8, 303, 304)
Polyethylene Caps; Nylon 6/6
316 Stainless Steel; Zinc-Plated
Steel; Stainless Steel 1x19
8mm Cable
310 lbs. (140.6kg)
2:1 for 900 lb. (4kN) maximum
fall arrest force and maximum
work radius of 14 ft. (4.3m)
14 ft. (4.3m) maximum work
radius, 360° (when used with a
truck as counterweight) - see
Fig. 3b; 14 ft. (4.3m) maximum
work radius, 180° opposite from
counterweights (when used
with alternate counterweights) -
see Fig. 4
1,800 lbs. (8kN) in direction of
fall; 36,000 ft.-lbs. (48,000 Nm) at
center of base
-
-