Lever With Kill Switch Model - Ultraflex B110B Manuel D'installation Et D'entretien

ULTRAFLEX

3.2.2 Lever with kill switch model

CAUTION
Avoid bending the cables too narrowly (minimum radius: 200 mm - 8"). The use of ULTRAFLEX cables is
recommended.
Refer to the dimensions indicated in paragraph 1.2 to verify that the box can actually be installed
1
in the chosen position.
After having established the appropriate
2
location, drill the necessary holes to insert the
mechanism with the help of the appropriate
template (supplied). The thickness of the lever
installation surface must not exceed 20mm
(0.7").
Fasten the flange (A1) and its gasket (A2)
4
by means of screws (F).
A2
A1
F
page 12
of 67 -
SINGLE LEVER CONTROL B110
F
Installation and maintenace manual
Screw switch (1) to the unit made up of
3
flange (A1) and gasket (A2) by means of nut (2).
1
A2
Fasten mechanism (A) to flange (A1) by
5
means of screws (G).
A
A1
G
A1 2