Motion Detector (Pir-Set) - Leitronic AG bebetelEXTRA Mode D'emploi

Mode cannot be changed using
touch tone commands
No activation

10.1 Motion detector (PIR-Set)

Problem
WALK-test LED is on, but
®
bébétel does not call
Call with three beeps without
prior movement (WALK-test LED
has been off all the time)
Call with two or three beeps was
triggered although the motion
detector was temporarily
deactivated
Used telephone set does not support touch tone or is
6.7 in the wrong mode mobile phone
pulse-dialling or an ISDN-telephone
Set volume of mobile A to a medium value (toggle
switch on the left or right side of the mobile phone)
After power on bébétel
minutes so you can leave your room without
triggering a call. Skip waiting period
during the
permanently green/blue
A call will be triggered depending on position of
sensitivity switch. As long as noise level is exceeded
the indication LED shines
Cause and/or remedy
Alarm unit is still in the inactive waiting period after
being switched on or after a call
Motion detector is temporarily deactivated
No voltage supplied to motion detector
check cable, AC-adapter and mains
Motion detector has been connected or disconnected
after the alarm unit had been switched on
Voltage supply of motion detector interrupted
Function switch has been shifted to OFF or PROG after
deactivation.
®
remains inactive for two
waiting period
the indicator is
6.6.1.
for instance
6.3.
6.7
19