Special Programming; Factory Setting; Call Repetitions - Leitronic AG bebetelEXTRA Mode D'emploi

9

Special programming

9.1 Factory setting

®
bébétel can be reset to default values as follows:
1. Set function switch to position OFF.
2. Keep .3 and .#
3. Set function switch to ON.
4. Release keys acknowledgement by a beep.
5. Set function switch to OFF.
Note:
If there is no beep at step 4, repeat steps 1 to 4.

9.2 Call repetitions

If you want to programme
1. Set function switch to PROG.
2. Press .* n
3. Enter .9 .7 .1 .3 .5 .3 <n>
4. Press .* n
5. Enter .9 .7 .1 .3 .5 .3 <n>
6. Press .# n
7. If the number is entered correctly there will be one beep at the end of the input. Wrong
re-entering will provoke two beeps. Incorrect number will not be stored so the former
value remains active.
8. Set function switch to OFF.
<n>
Comment
®
0 bébétel just dials once for each condition (default value)
®
1..9 bébétel re-dials after the waiting period if a call was not acknowledged by pressing
.0. on your telephone. The number of call repetitions is limited to the value of n.
Note:
If you use the motion detector we recommend setting call repetitions because it is
possible that the child may cross the monitored section once only.
If call recipient is "busy", the waiting period between two calls is 30 seconds, otherwise 2
minutes.
If calls are repeatedly made to an answering machine additional costs can be incurred.
If you key a wrong number set function switch to OFF and repeat steps 1 to 7.
16
pressed simultaneously.
call repetitions
(n
once again for confirmation.
you can proceed as follows:
see table below).