Programming; Program The Telephone Number; Programme Pin-Code / Bluetooth-Access-Code - Leitronic AG bebetelEXTRA Mode D'emploi

5

Programming

5.1 Program the telephone number

1. Set function switch to PROG.
2. Enter telephone number where you can be
reached (phone B). Each key stroke will be
acknowledged by a beep (24 digits at most).
3. Set function switch to OFF.
Note:
Check if the new telephone number is correct:
The telephone number remains stored even when bébétel
If you use bébétel
i.e. 0044 for
0044 21 234 56 78.
Key * makes bébétel
If you key a wrong number set function switch to OFF and repeat steps 1 to 3.
Following notes are only relevant when you use a landline:
Key # introduces a dialling delay of 5 seconds between two digits: e.g. when you are at
a hotel and you need to dial a number, often 0 or 9, in order to get an external line then a
delay must be added after first digit (first digit + #. + telephone number). Example:
0#021 234 56 78.
If your private exchange uses flash-pulse to start an internal call you can program as
follows: .2 + #. followed by internal telephone number. Example: 2#99.

5.2 Programme PIN-Code / Bluetooth-Access-Code

The PIN-Code for remote dial-in to listen to your child
can be programmed as follows:
1. Set function switch to PROG.
2. Press key .#
.
3. Enter PIN-Code (4 to 7 digits).
4. Press key .#
.
5. Enter PIN-Code again for confirmation.
6. Press key .#
.
7. Set function switch to OFF.
Note:
The PIN-code remains stored even when bébétel
If PIN-code is re-entered correctly there is an acknowledgement beep at the end of input.
Wrong re-entering of PIN-code will provoke two beeps. PIN-code will then not be stored
so the old PIN-code remains active.
PIN-code must consist of min. 4 and max. 7 digits.
Factory setting of PIN-code is 9797. We recommend programming a personal PIN-code
for safety reasons.
If you key a wrong number set function switch to OFF and repeat steps 1 to 7.
6
®
abroad, you have to add the country-code to the telephone number:
0041 for , 0047 for
,
®
to hang up after 5 seconds.
OFF ON
PROG
6.4.
®
is switched off.
0049 for . Example if you are in a hotel:
,
6.9 or Bluetooth-Access-Code
OFF ON
PROG
®
is switched off.
OFF ON
PROG
4.1
OFF ON
PROG