Motion Detector Bbt-Pir-Rj45 (Pir-Set); Warming Up Phase - Leitronic AG bebetelEXTRA Mode D'emploi

8.5 Motion detector BBT-PIR-RJ45 (PIR-Set)

To receive a call even if the child leaves the room without making any
noise, you can connect a motion detector. Connect the motion detector
and the AC-adaptor to the EXT connectors. Direct the motion detector so
that it monitors only the exit of the room.
8.5.1 Mounting
The motion detector should be located so that a child will cross the
infrared beam pattern. If the child is sleeping within the range, a movement of the child can
cause a false alarm. Figure shows the different infrared beam patterns at a typical mounting
height of 2.5m.
Note:
Do not mount detector towards direct sunlight or near to
heat sources.
The landline telephone-cord must be disconnected before
wiring of AC-adapter or motion detector can be carried out.
Do not mount detector behind items like glass or curtains
because the infrared-beam cannot penetrate them.
Keep away pets like cats or dogs from the protected area.
8.5.2 Connection
Plug the cable of the motion detector to one of the
connectors of the bébétel
connect or disconnect motion detector cable while bébétel
alarm call will be triggered.
8.5.3

Warming up phase

Wait at least two minutes after applying power to let the motion detector stabilize. Walk
through the entire area you want to be monitored and observe the red light on the motion
sensor to ensure full coverage. Adjust swivel if necessary.
8.5.4 Adjustments
Disconnect motion detector before opening. Remove the front cover by twisting a flat
screwdriver in the slot between the cover and the base at the bottom of the motion sensor.
®
. The motion detector is powered by the AC-adaptor. Do not
8 EXT
®
is switched on, otherwise a
15