Battery Check/Replacement; Maintenance; Accessories; Telephone Extension Cord - Leitronic AG bebetelEXTRA Manuel D'utilisation

7.7 Battery check/replacement

®
If bébétel
emits three beeps when switched on battery must be replaced.
Note: Disconnect the telephone-line before opening battery compartment. This is to avoid contact
with dangerous telephone network voltage!
1. Set function switch to OFF
2. Open battery compartment and remove old battery
3. Insert new battery and close battery compartment
Note:
Always use faultless 9 V-batteries.
Recycle old batteries properly.

7.8 Maintenance

Set function switch to OFF and remove telephone cord. Clean bébétel
dry it afterwards. Note: Do not use cleaning agents or solvent.
8

Accessories

Below you will find a list of accessories. More items and detailed information are available on our homepage
www.bebetel.com

8.1 Telephone extension cord

If enclosed cord is not long enough you can buy an extension cord.

8.2 Use abroad

®
bébétel
is approved for European countries (CTR-21) and for USA/Canada
(FCC). It can be used worldwide. The only requirement is an analogue phone
connection. Please note that there are different telephone-adapters for different
countries. We recommend buying a special traveller-adapter-set.

8.3 Smoke detector

The smoke detector has an integrated alarm siren. It can be installed on the ceiling. The alarm
forwarding happens indirectly by the acoustic room monitoring.
no wiring necessary.
stand-alone usable.

8.4 PIR-Motion detector BBT-PIR-RJ45 (COMBI)

8.4.1 Preliminary considerations
Choose the mounting location after careful consideration of the area to be
protected. The motion detector should be located so that an intruder/child
will cross the infrared beam pattern. If the child is sleeping within the
range, a movement of the child can cause a false alarm. Figure shows the
different infrared beam patterns at a typical mounting height of 2.5m.
Note:
Do not mount detector towards direct sunlight or near to heat sources.
Do not mount detector behind items like glass or curtains because the
infrared-beam cannot penetrate them.
Keep away pets like cats or dogs from the protected area.
8.4.2 Connection
Plug the cable of the motion detector to one of the
powered by the AC-adaptor.
Note:
A call will be triggered if you connect or disconnect the motion detector during operation.
®
if necessary with a moistened cloth and
EXT connectors of the bébétel
8
®
. The motion detector is
51