IKEA FRYSA Mode D'emploi page 6

Masquer les pouces Voir aussi pour FRYSA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Use the refrigerator compartment
only for storing fresh food and
the freezer compartment only for
storing frozen food, freezing fresh
food and making ice cubes. Avoid
storing unwrapped food in direct
contact with internal surfaces
of the refrigerator or freezer
compartments.
Appliances could have special
compartments (Fresh Food
Compartment, Zero Degree
Box,...). In case not differently
specified in the specific booklet
of product, they can be
removed, maintaining equivalent
performances.
C-Pentane is used as blowing
agent in the insulation foam and it
is a flammable gas.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply (if any) and electrical
connections, and repairs must
be carried out by a qualified
technician. Do not repair or
replace any part of the appliance
unless specifically stated in the
user manual. Keep children away
from the installation site. After
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.)
must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
from the power supply before
any installation operation - risk of
electrical shock. During installation,
make sure the appliance does not
damage the power cable - risk
of fire or electrical shock. Only
activate the appliance when the
installation has been completed.
Be careful not to damage the
floors (e.g. parquet) when
moving the appliance. Install the
appliance on a floor or support
strong enough to take its weight
and in a placesuitable for its size
and use. Make sure the appliance
is not near a heat source and
that the four feet are stable and
resting on the floor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on,
to ensure that the refrigerant circuit
is fully efficient.
WARNING: To avoid a hazard
due to instability, positioning
or fixing of the appliance must
be done in accordance with the
manufacturer instructions.
6

Publicité

Table des Matières
loading

Table des Matières