Sonnenkonig MARS Mode D'emploi page 41

3. Installation
A wall mounting bracket is provide with the heater which
has been specifically designed to allow this product to be
fitted to a wall or ceiling before drilling the holders for the
wall/ceiling is solid and that there are no hidden water
pipes or electric wires. The heater must be installed no
less than 16'' (41 cm) from side walls and no less than 6"
(16 cm) off the floor.
Important: Ensure that the supply cables is well moun-
ted and that it does not come into contact with reflector
of the heater or that does not trail into heated area, the
supply cable can be fixed to the metal mounting bracket behind heater with plastic zip ties.
1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before instal-
lation.
3. This heater can be mounted in a horizontal or vertical manner.
4. For both wall and ceiling mounting, the lowest part of the heater must be located at or above
a minimum height of 1.8m from ground level, so that the heater can not be touched when
in operation.
5. When mounting horizontally or to a ceiling, do not position the heater at an angle more
than 90°and less than 45°as shown in Fig. A and B.
6. The supply cable must be at the lower end of the heater if the heater is installed at an angle
or vertically.
7. Keep the supply cord away from the body of the heater which will get hot during use.
8. Do not install the heater on an inflammable surface.
9. Observe the minimum safe distance between the heater body and the inflammable surfaces
when mounted.
10. The heater should always have a minimum clearance of 0.5m from a ceiling and adjacent
walls.
11. If the heater is to be used outside, a weatherproof outlet is recommended.
12. Before drilling ensure that there are no wires or water pipes in the area where the heater is
to be installed.
13. The heater must be installed on the mounting brackets provided.
14. Fasten the brackets securely to the mounting surface and the backside of the heater using
the nuts and screws supplied.
15. Fasten the heater securely on the brackets using the nuts and bolts supplied.
16. The brackets can be used to adjust the direction of the heater, adjust the heater angle by
loosening the two bolts on the wall mounting bracket, tighten the bolts again when the
desired angle is reached.
41