ENGLISH
Thank you for buying this product, our company is sure that you will be more
than satisfied with the product's performance. The product is supplied with
a "Warnings" leaflet and an "Instruction booklet". These should both be
read carefully as they provide important information about safety, installa-
tion, operation and maintenance.This product complies with the recognised
technical standards and safety regulations. We declare that this product
is in conformity with the following European Directives: 89/336/EEC and
73/23/EEC (and subsequent amendments).
1) GENERAL OUTLINE
This controller has been designed to motorize counter-balanced overhead
doors.The compactness and versatility of the installation allow the motor drive to
be fitted to almost any model of overhead door where it can be installed both in
the centre and at the side. It is particularly recommended for residential use.
The irreversible gearmotor keeps the door locked in the closing position
without electric lock.
In the case where the mains power supply is off, release is activated from
the inside by means of an appropriate knob. The release device if provided
with microswitches, which stop the motor both on opening and on closing,
and with a timed courtesy light.
2) SAFETY
If correctly installed and used, this automation device satisfies the required
safety level standards. However, it is advisable to observe some practical
rules in order to avoid accidental problems.
Before using the automation device, carefully read the operation instructions
and keep them for future reference.
•
Keep children, persons and things outside the automation working area,
particularly during operation.
•
Keep radio control or other control devices out of children's reach, in
order to avoid any unintentional automation activation.
•
Do not intentionally oppose the leaf movement.
•
Do not attempt to open the gate by hand, if the actuator has not been
released by means of the appropriate release knob.
•
Do not modify the automation components.
•
In case of malfunction, disconnect the power supply, activate the emer-
gency release to gain access to the actuator and request the assistance
of a qualified technician (installer).
•
Before proceeding to any external cleaning operation, disconnect the
mains powers supply and at least one of the battery pole, if fitted.
•
Keep the photocell optical components and luminous signal indication
devices clean.Check that the safety devices (photocells) are not obscured
by branches or shrubs.
•
For any direct assistance to the automation system, request the assistance
of a qualified technician (installer).
•
Have qualified personnel check the automation system once a year.
3) MANUAL RELEASE
The manual or emergency release is to be activated when the door must
be opened manually, and any time the operator stops working or shows
malfunctions. To carry out the emergency manoeuvre, proceed as follows:
•
Access the release knob by sliding its cover C until it stops (Fig.1).
•
Rotate the release knob by 90° anticlockwise (Fig.1).
•
To restore motor-driven operation, return the knob to its original posi-
tion.
4) BULB REPLACEMENT
To replace the courtesy light bulb, remove its transparent cover (Fig.2).
WARNING: Only 24V
25W max E14 bulbs must be used.
Do not remove protection sheath "G" while replacing the bulb.
5) MAINTENANCE AND DEMOLITION
The maintenance of the system should only be carried out by qualified
personnel regularly. The materials making up the set and its packing must
be disposed of according to the regulations in force.
WARNINGS
Correct controller operation is only ensured when the data contained
in the present manual are observed. The company is not to be held
responsible for any damage resulting from failure to observe
the installation standards and the instructions contained in the
present manual.
The descriptions and illustrations contained in the present manual are
not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product fea-
tures unchanged, at any time and without undertaking to update the
present publication.
4 -
PHEBE Ver. 03
USER'S MANUAL
Fig. 1
Fig. 2
24V
25W
G