Operation - Dimplex BLF50-EU Manuel De L'utilisateur

Operation

the manual controls for the
electric fireplace are located on
the right side of the unit and inside
the air intake slot (Figure 12).
Figure 12
A. 3-Position Switch
the switch has two (2) on
positions marked with "I" and
"II". the "I" position is for manual
operation. In this position
the built-in remote control is
bypassed.
The "II" position is for operating
the unit with the provided remote
control. When in "II" position
the unit is operated with the ON
and OFF buttons of the remote
control.
When the switch is in the center
("O") position the unit is off.
14
A
B
B. Heat On/Off Switch
the Heat on/off switch supplies
power to the heater fan and the
heater element.
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
3-Position switch to off and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and contact
your local dealer.
Remote Control
the fireplace is supplied with an
integrated on/off
Where the maximum rage of use
is ~15m.
WARNINg: It takes time for
the receiver to respond to the
remote control. Do not press the
buttons more than once within
two seconds for correct operation.
!
NOTE: Ensure that the
fireplace 3-Position Switch
is set to the remote control
setting ("II").
(Figure 13)
remote control.
www.dimplex.de