Explanation Of Buttons; Opperation - Tunturi E35 Manuel De L'utilisateur

English
Speed
- Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED will
display "0.0"
RPM
- Displays the Rotation Per Minute.
Display range 0~15~999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
WATTS
- Display current workout watts.
- Range 0 ~ 999
LOAD
- Shows tension level setting, when adjusting
resistance, for 3 seconds.
Distance
- Without setting the target value, distance will count
up.
- When setting the target value, distance will count
down from your target distance to 0 with an alarm
sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will count
up.
- When setting the target value, calories will count
down from your target calorie to 0 with an alarm
sound or flash.
- Range 0~9999.
NOTE
• This data is a rough guide for comparison of
different exercise sessions which cannot be used
in medical treatment
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console will
display "P".
- Pulse alarm will sound when current pulse is over
the target pulse.
- Range 0-30~230 BPM

Explanation of buttons

Up
- Increase resistance level
- Setting selection.
Down
- Decrease resistance level
- Setting selection.
Mode
- Confirm setting or selection.
Reset
- In setting mode, press RESET key once to reset the
current function figures.
- Press RESET key and hold for 2 seconds to reset all
function figures
Start/ Stop
- Start or Stop workout
Body Fat
- Test body fat% and BMI in stop mode.
Recovery
- Test heart rate recovery status.

Opperation

Power on
- Plug in power supply to power on computer.
- Press any key to power on the console when being
in sleep mode..
- Start pedalling to power on the console when being
in sleep mode.
LCD will display all segments (fig. - F-01)
Power off
Without any signal being transmitted into the monitor
for 4 minutes the monitor will enter SLEEP mode
automatically. ( Active training data will be lost )
Workout selection
Use UP/ DOWN to select:
- Manual
- Program
- User Program
- H.R.C.
- Watt
1 6