Ducati MG-20 Manuel D'utilisation page 27

Checking the parts
The supporting frame of the pedal-assisted bicycle and the welds must be free of visible
defects such as: cracks, deformations, incisions, corrosion, etc.
Make sure that all the bolts and pedals of the pedal-assisted bicycle are properly
tightened.
Check the condition and attachment of the battery, the electrical cable sleeves must be
in good condition, and the terminals must be well tightened and not corroded.
Check the battery charge status using the indicator on the handlebar display.
For proper use of the battery in your EPAC vehicle, we recommend that you always
charge the battery after each use of the bicycle.
Using the inflation valve on the rims, check the inflation pressure of the tyres using
a compressor and a pressure gauge gun or a workshop pump.
Check the condition of the tread, the rim and the attachment of the rims to the
hubs. If you need to replace the tyres, contact the Support Service or a qualified
tyre dealer.
The brakes must be adjusted in such a way as to ensure effective braking, and
at the same time the control levers must have a range sufficient for modulating
braking: in other words, the brakes must be neither too loose nor too tight.
25