Maintenance Instructions - Ducati MG-20 Manuel D'utilisation

10. Maintenance instructions

All maintenance operations must be performed with the system switched off, the
battery disconnected and the bicycle resting on the stand.
After each routine maintenance operation, a check on the perfect functioning of all
controls is advised.
This manual does not go into detail about disassembly and non-routine maintenance, as
these operations must always be carried out exclusively by the Support Service staff of
your authorised Ducati Urban e-Mobility dealer.
The Support Service is able to provide all the information you will need and answer all
your requests regarding the perfectcare and maintenance of your pedal-assisted bicycle.
ATTENTION
Check with negative results
• If even a single check has a negative result, do not ride the pedal-assisted bicycle.
• Immediately take all measures to perform a suitable repair and if necessary, contact the
Support Service of your dealer.
Washing
Cleaning the pedal-assisted bicycle is not only a matter of decorum but also makes it
possible to immediately detect any defect in the bicycle.
In order not to damage or impair the operation of the various components, especially
the electrical parts, cleaning must be carried out while taking certain precautions. It is
absolutely forbidden to direct pressurised water jets towards the electrical parts, the
motor, the display and the battery, for which sponge washing is recommended.
Before starting the pedal-assisted bicycle, dry completely with a cloth or paper, being
careful not to scratch the painted components. Avoid using compressed air, especially
at close range and high pressure. Check that there is no residual moisture left on the
electrical components.
Chain lubrication
It is important to lubricate the chain regularly, to avoid excessive wear and to prolong its
life.
1. Clean the entire length of the chain links with a rag.
2. Spray all chain links with a special lubricant spray for transmission chains.
24