Ducati MG-20 Manuel D'utilisation page 16

Put on the road
Before using the pedal assisted bicycle, to ensure the efficient "putting on the road"
of the product, it is advisable to carefully check each part and provide for adequate
adjustment intervention of the relative mechanical components, directly or with the
support of specialized operators, e.g. adjustment and tightening of the handlebars and
stem, adjustment and tightening of the saddle and seat post, adjustment of the brakes,
adjustment of the gearbox, tire pressure check, chain and gears lubrication, correct
tightening of the fixing screws check and general check of all parts. It is recommended
that the putting on the road services be carried out by qualified personnel.
Wheels
Check the tyre inflation pressure, referring to the values on the tyre shoulder. Check
the state of wear of the rubber: there must be no cuts, cracks, foreign bodies, abnormal
swellings, exposed canvas and other damages.
Brake system
Check the operation of the brakes with a low-speed braking test (max. 6 km/h) in an
obstacle-free zone, first with the rear brake and then with the front brake.
ATTENTION
Check with negative results
In the event that defects of any kind are found during the preliminary checks and even a
single check has negative results, do not ride the pedal-assisted bicycle.
Activate all measures immediately to make a proper adjustment, and if necessary,
contact the Support Service.
14