Shimano Steps RIDE+ Manuel Du Propriétaire page 56

Symptom
The battery and charger are
becoming hot.
The charger is warm.
The LED on the charger
does not illuminate.
The battery cannot be
removed.
The battery cannot be
inserted.
Fluid is coming out from the
battery.
An abnormal odor can be
detected.
Smoke is coming out from
the battery.
Lights
Symptom
The front light or the tail
light does not illuminate
even when the switch is
pressed.
Cause / Possibility
The temperature of the battery or charger
may exceed the operating temperature
range.
If the charger is being used continuously to
charge batteries, it may become warm.
Is the recharging plug of the charger
securely inserted into the battery?
Is the battery fully charged?
Cause / Possibility
The E-TUBE PROJECT settings may be
wrong.
Stop recharging, wait for a while and then
recharge again. If the battery is too hot to
touch, it may indicate a problem with the
battery. Contact the place of purchase.
Wait a while before using the charger
again.
Check the connection for any foreign
objects before reinserting the charging
connector. If there is no change, contact
the place of purchase.
If the battery is fully charged, the LED on
the battery charger turns off, but this is not
a malfunction. Disconnect and then
reconnect the power plug of the charger,
and then repeat the recharging operation.
If the LED on the charger still does not
illuminate, contact the place of purchase.
Contact the place of purchase.
Contact the place of purchase.
Contact the place of purchase.
Stop using the battery immediately and
contact the place of purchase.
Stop using the battery immediately and
contact the place of purchase.
Contact the place of purchase.
50
Remedy
Remedy