Speedaire 3Z411A 20 HP Mode D'emploi & Nomenclature Des Pièces page 6

Speedaire Operating Instructions & Parts Manual
Speedaire
Air Compressor
IMPORTANT: Do not reset.
If the pressure relief valve pops,
it indicates trouble. Shut down
the unit immediately and
determine and correct the
malfunction. Inspect the head
E
valves. Serious damage can
N
result if not corrected and can
G
lead to complete destruction of
L
the unit. Tampering with the
I
interstage pressure relief valve,
S
H or plugging the opening destroys
the protection provided and
voids all warranty.
LUBRICATION OF
COMPRESSOR
Fill crankcase to proper level as
indicated by oil sight gauge.
Keep crankcase filled as required
by usage.
AIR COMPRESSOR OIL
SPECIFICATIONS
Compressor are factory filled
with SPEEDAIRE hydrocarbon
based recip lubricant. This is an
ISO 100 non-detergent industrial
lubricant with rust and oxidation
inhibitors specially formulated
for reciprocating compressors. It
is recommended this compressor
be maintained using this oil for
ambient temperatures
above 32°F.
® 20, 25 & 30 HP Two-Stage
SPEEDAIRE synthetic is a
premimum grade diester based
synthetic lubricant providing
excellent performance in high
temperature applications.
types, weights or brands.
of oil (white milky substance)
indicates unsafe accumulation of
moisture and may be evidence
compressor is oversized for
application. Failure to promptly
consult your local distributor, or
Speedaire Customer Service, can
be grounds to deny warranty."
NOTES:
1. Normal break-in period of
Speedaire air compressors
is 25 hours.
2. For the first 100 hours of
compressor operation, a
careful and regular check of
the oil level should be made.
Maintain oil level at the full
line.
CHANGING TO SYNTHETIC
LUBRICANT.
(Applies to diester based
synthetic lubricant only).
If changing to synthetic lubricant,
the following steps must be
completed.
Do not mix oil
"Emulsification
6
3Z411A
1. Compressor must run for a 25
hour break-in period using
ChampLub ISO 100 oil.
2. Thorougly drain existing oil
from crankcase.
3. Fill crankcase with a full
charge of synthetic lubricant.
4. Run compressor for 200 hours.
5. Stop compressor and
thoroughly drain the synthetic
lubricant.
6. Add a full charge of synthetic
lubricant.
7. Compressor now ready to run
for extended period before
next lubricant change.
LUBRICANT
PART
DESCRIPTION
NUMBER
1 Quart Bottle
Speedaire 1WD50
Mineral
1 Quart Bottle
Speedaire 1WD49
Synthetic