Displaying The Firmware Version Of The Printer; Adjusting The Position Of The Printout Image - Sony UP-DR150 Instructions D'utilisation

To display the total number of printings
made so far since you started to use the
printer:
Select "TOTAL PRINTS".
F f
Press and to display TOTAL PRINTS.
Total number of printings since turning on the printer
3
Press the MENU button after confirming.
The printer returns to the on-line mode, and the
ONLINE indicator lights.
Displaying the Firmware Version of
the Printer
The version of the firmware of the printer can be
displayed.
2
1,3
1
Press the MENU button.
The printer is switched to off-line.
2
Press the F and f buttons to display VERSION.
F f
Press and to display VERSION.
Version of the firmware of the printer
3
Press the MENU button after confirming.
The printer returns to the on-line mode, and the
ONLINE indicator lights.
Adjusting the Position of the
Printout Image
You can adjust the position of the printout image as
shown in the illustration in step 3, below, for the 2UPC-
R153/R153H and the 2UPC-R155/R155H. Adjust the
image position, as required, or when the blank portion
appears on the edge of the printout.
1,4 2
1
Press the MENU button.
The printer is switched to the off-line mode.
2
Press the F and f buttons to display PRINT
OFFSET.
F f
Press and until PRINT OFFSET appears.
The offset amount for the current position
3
Press the G and g buttons to shift the printout image
to the desired position, while looking at the
printout.
L1: Moves to the left by 0.6 mm from the default
position.
L2: Moves to the left by 1.2 mm from the default
position.
R1: Moves to the right by 0.6 mm from the default
position.
3
23
Menu Operations