Attaching The Paper Tray - Sony UP-DR150 Instructions D'utilisation

high humidity or dust,
direct sunlight.
• After opening the bag, use the ribbon and the paper as
soon as possible.
• When storing after partial use, put the ribbon and the
paper back in their respective bags.

Attaching the Paper Tray

Attach the supplied paper tray as illustrated.
Scrap stoppers
Note
When printing, a margin is left between printouts. The
excess portions of margins are cut and dropped into the
scrap receptacle part of the paper tray. Scrap stoppers are
attached to the tray so that these excess margins are
dropped into the proper part of the paper tray. Be careful
not to bend these scrap stoppers. Doing so may result in
the paper scraps missing the receptacle and being
ejected onto the tray together with the printouts. As a
result, the printouts may be damaged.
You have to adjust the length of the paper tray according
to the printing pack to be used.
When using the 2UPC-R153/R153H or
2UPC-R154/R154H Printing Pack
About 30 sheets of printouts can be left on this paper
tray. However, the number of printouts which can be
accumulated on the paper tray changes according to the
environment condition where the printer is used or the
printed image. Remove the printed sheets accumulated
on the paper tray as soon as possible.
Note
When the 2UPC-R155/R155H or 2UPC-R156/R156H
printing pack is used, paper jamming may occur if you
use the paper tray as illustrated above.
For details, see the "When using the 2UPC-R155/
R155H Printing Pack" and "When using the 2UPC-
R156/R156H Printing Pack" following.
When using the 2UPC-R155/R155H
Printing Pack
Pull the support out, and raise the
stopper.
About 20 sheets of printouts can be left on this paper
tray. However, the number of printouts which can be
accumulated on the paper tray changes according to the
environment condition where the printer is used or the
printed image. Remove the printed sheets accumulated
on the paper tray as soon as possible.
Loading the Paper Roll and Ink Ribbon
15