RIDGID Power-Spin 41408 Mode D'emploi page 9

other liquid barrier gloves under the
leather gloves.
1. Check work area for:
• Adequate lighting
• Clear, level, stable, dry place for ma-
chine and operator. Do not use the ma-
chine while standing in water. If needed,
remove the water from the work area.
2. Inspect the drain to be cleaned. If possi-
ble, determine the access point(s) to the
drain, the size(s) and length(s) of the
drain, distance to mainlines, the nature of
the blockage, presence of drain cleaning
chemicals or other chemicals, etc. If
chemicals are present in the drain, it is
important to understand the specific
safety measures required to work around
those chemicals. Contact the chemical
manufacturer for required information.
3. Determine the correct drain cleaning
equipment for the application. The Power-
Spin is made for:
• Up to 1 1 / "(40 mm) lines up to 25' (7,6 m)
2
long with 1 / "(6 mm) cable.
4
• Drain cleaners for other applications can
be found by consulting the Ridge Tool
Catalog, on line at www.RIDGID.com or
by calling RIDGID Tech nical Services at
800-519-3456.
4. Make sure machine has been properly in-
spected.
5. If needed, place protective covers in the
work area. The drain cleaning process
can be messy.
6. If using the Power-Spin by hand, make
sure that the crank is present and firmly
attached.
7. If using the Power-Spin with a battery
powered drill, remove the crank from the
back of the drum by pressing the tabs on
the either side (See Figure 2) . Securely
attach the chuck of the drill to the drum
shaft.
POWER-SPIN ®
Warning
Label
Figure 2 – Removing Crank Handle From Power-
Spin
8. If needed, take appropriate steps to ac-
cess the drain to be cleaned.
• For many drains, the cable can be
threaded through the cross hairs in
the drain (See Figure 3).
• For a sink with a pop up drain plug:
Remove lift rod and drain plug (See
Figure 4) . Be sure to place a container
under the clean out or trap to catch
any water that may come out.
• For other sinks a clean out plug or
trap may need to be removed (See
Figure 5.) Be sure to place a con-
tainer under the clean out or trap to
catch any water that may come out.
• For bathtubs, never try to go through
the drain, this will damage the cable.
Remove the overflow plate and any
mechanism to access the drain (See
Fi gure 6) .
Cross
Hairs
Figure 3
Clean-out
Plug
Figure 5
9. Determine if the Power-Spin can be
placed within 4" (100 mm) of the drain
Drain Cleaner
Drum Shaft
Drain
Plug
Set
Screw
Cap
Nut
Lift Rod
Figure 4
Figure 6
7