Lenz Digital plus GOLDmini+ Manuel D'utilisation page 32

32 Information GOLDmini+
5.11 Coupling control
The decoder allows for a comfortable controlling of remote couplings at function outputs A, B and C.
The selected output provides full power for a settable period of time (kick duration) and reduced
power after this period has expired. By how much the power is decreased can be set using the
value for brightness for the choosen output. You can also set if and how long the locomotive is to
move during the coupling process.
5.12 USP - Uninterruptable Signal Processing
In combination with the optional energy storage, the intelligent USP circuit ensures that your
locomotive can run even over dirty track sections or dead frogs. The energy storage is not included
with this decoder and is installed separately in the vehicle.
Soldering surfaces are provided on the decoder for the connection of the energy storage (e.g.
Power 1), see Abb. 4, p. Fehler! Textmarke nicht definiert.. Solder the respective cable of your
energy storage to the soldering surfaces. Make sure that you do not create short circuits to other
soldering surfaces or between soldering surfaces.
5.13 RailCom
The Decoder is equipped with the RailCom function. In addition to the locomotive address, other
data (e.g. speed, CV content) can be transmitted from the locomotive via the track back to the
system. The information sent is received by a RailCom detector and then displayed. Which data
the decoder is to send is set in CV28. Set Bit 4 in CV29 to enable the transmission function.