Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The keys of your SpeakerLink 65 Remote then have another function:
CHAN+ :
On
CHAN- :
Off
VOL+ :
Brighten lights
VOL- :
Dim lights
POWER :
All Lights On
M (mute) : All Lights Off
4.7 Searching for and identifying codes
Searching for codes
1.
Turn on the device you want to control.
2.
Press and hold SETUP until the LED indicator lights steadily. Release the Setup button.
3.
Press the mode button that matches the equipment you want to control (TV, VCR, DVD, SAT,
CD). The LED blinks once.
4.
Press CHAN+ repeatedly (note 5, chapter 4.6) until the device to be controlled changes
channel.
If you by mistake go past the code, press CHAN- repeatedly until the channel changes again.
5.
Press and release the ENTER button to complete the setup.
The above assumes that you want to store VCR codes under the VCR button, CD codes under CD,
etc. If you want to store a VCR code under CD, etc., first follow the procedure in chapter 4.6 and
try ANY VCR from the code tables, e.g. press CD (as in step 3, chapter 4.6), and then enter ANY
VCR code. Then follow the steps above.
Identifying a found code
1.
Press and hold SETUP until the LED indicator lights steadily. Release the Setup button.
2.
Press the mode button that matches the equipment you want to identify (TV, VCR, DVD, SAT,
CD). The LED blinks once.
3.
Press and release SETUP. The LED blinks once.
4.
To find the first digit, press each number button from 0 to 9 until the LED blinks. The number
you pressed is the first digit of the code.
5.
Press each number button from 0 to 9 again as above to find the second digit.
6.
Press each number button in to find the third digit. When the third digit has been found, the
LED goes out.
4.8 Learning commands
1.
Point your existing remote at the Marmitek SpeakerLink 65 Remote (front to front) with a
distance of about 2,5 centimetres between the remotes.
2.
Press and hold SETUP until the LED indicator lights steadily.
3.
Press the mode button (TV, VCR, DVD, etc.) that matches the equipment you wish to learn.
The LED blinks once.
4.
Press and release the LEARN button. The LED blinks once.
5.
Press and release the button on the Marmitek Remote that you want to teach. The LED blinks
once.
8
MARMITEK
Publicité
Table des Matières
