Installing The Batteries; Battery Saver; Button Descriptions - Marmitek SPEAKERLINK 65 Mode D'emploi

This lets you control the volume, balance, bass, treble, etc. of the speakers connected to the
SpeakerLink 65 from anywhere inside or outside your home.
You can also control your existing equipment with the SpeakerLink 65 Remote. You can do this
directly, by IR-technology, and through walls and floors, by RF-technology. For more information, see
chapter 5.
When used with an additional MP3-receiver (art. nr. 09255) and software, it can also control an
MP3, DVD, and CD player in your PC. For more information, look at www.marmitek.com .

4.1 Installing the batteries

1. Push the tab and lift off the battery cover.
2. Insert four AAA alkaline batteries, taking care to match the + and - marks in the battery
compartment.

4.2 Battery saver

Your SpeakerLink 65 remote will automatically "time-out" if the keys are depressed for more than
two minutes. This will save your batteries should your remote get stuck in a place where the keys
remain depressed (e.g., between the sofa cushions).
4.3 Code saver (important)
You will have up to 90 seconds to change the batteries in your remote without losing codes you
have programmed. However, do not press any buttons until batteries are installed in the remote. If
buttons are pressed without batteries in the remote, all codes will be lost.

4.4 Button Descriptions

INDICATOR LIGHT
The indicator light flashes when you press any button.
POWER
Works the same as your original remote.
TV, VCR, DVD, SAT, CD, AUDIO
Used to select the device to control (AUDIO selects the SpeakerLink 65 Wireless Amplifier/Speaker
Driver).
SET UP
Used for programming the remote.
LEARN
Your Marmitek SpeakerLink 65 Remote has the codes for most TV's, VCR's etc. in its code library.
However, if the code for your particular device is not found in the library, you can learn these codes
from your existing remote. Or if you find a code from the tables in this manual that "almost"
matches your device, but a few buttons are missing, you can learn just those buttons.
VOL +/-
Works like your original remote. Also, after you first press AUDIO followed by AMP (button 4) VOL+
increases volume on both channels VOL- decreases volume on both channels on the SpeakerLink 65
Amplifier/ Speaker Driver.
SPEAKERLINK 5