Marmitek SPEAKERLINK 65 Mode D'emploi page 11

8 TROUBLESHOOTING
The remote won't control your A/V equipment, or doesn't work at all:
• Use manual controls or the original remote control to confirm the equipment is working
properly.
• Be sure you pressed the device key for the device you want to control.
• Re-enter the code for your A/V product from the code listings on the separate sheet
(included).
• Try searching for codes as described in chapter 4.7.
• Replace the Remote's batteries.
If you are not getting any sound at all from the Speakerlink 65
• Check that the CHANNEL slide switches (labelled A, B, C, D) on both units have been set to the
same letter.
• Check that both the transmitter's and receiver's power supplies have been plugged in. Check
that the ON/OFF switches on the transmitter and receiver are in the ON position.
If the sound is poor, or there is interference
• Try changing the channel on both units. Do this by adjusting the CHANNEL slide switch on
each unit to any position (A, B, C, or D).
• Make sure both units are set to the same letter. Try repositioning the antenna on each unit.
SPEAKERLINK 11