Cleaning The Gasket; Cleaning The Milk Foamer; Important - Nuova Simonelli Microbar Mode D'emploi

9.9 CLEANING THE
GASKET
• Use a small brush to clean any deposits or coffee
residues off the piston and the delivery unit site
or any other areas soiled with coffee.
9.10 CLEANING THE MILK
FOAMER
NOTA: Follow the instructions applied on the label on
the inside of the front door too.
• Set the machine to the "O" energy level.
• Insert the key in the lock.
• Turn the Front panel opening key counter-
clockwise.
• Open the Front panel.
IMPORTANT: Proceed with caution
• Extract the whole delivery unit including the milk
foamer, pulling it towards you.
• Extract the milk foamer from the delivery group by
sliding it upwards.
70
• Disconnect all the tubes attached to it.
• Disassemble the milk foamer and wash it careful-
ly.
Fig. 45
Fig. 46
NOTE: If the pause between one cappuccino and
another is over one hour long, it is advisable
to wash the milk foamer by fishing the milk
suction tube in hot water rather than in milk.
• To reassemble proceed inversely, attaching the
milk foamer tubes properly.
NOTE: To make the reassembling procedure easier,
an explanatory label has been attached to
Fig. 46
the front door.
• Clean the drop collector (see paragraph THE
DROP COLLECTING TRAY GRID).
Fig. 47
2
1
EN
Fig. 48
Fig. 49