BH FITNESS G156 Instructions De Montage Et Utilisation page 31

Fig.5
(73) Self locking M-8.
(112) Bolts M-8x50.
(113) Bolts M-8x45.
(114) Bolts M-8x30.
(115) Bolts M-8x20.
(116) Bolts M-8x16.
(117) Slot head bolt M-10x20.
(118) Countersunk screw 5/16"x3/8".
(119) Flat washers M-8/20.
(120) Flat washers M-8.
(121) Flat washers M-10.
(122) Washers M-10.
(123) Flat washers M-12.
(124) Flat washers 38x11XT4.
(126) Self locking M-10.
(127) Self locking M-12.
(128) Bolts M-10x34.
1.- ASSEMBLY.-
Place the
horizontally, as shown in Fig.6.
2.- Place the rear support (2) on the
main support (1), as shown in Fig.6, fit
screws (101) along with the curved
washers (122) and nuts (126) and
tighten.
3.- Position the front support (3), as
shown in Fig.6, fit screws (101) along
with the curved washers (121) and
nuts (126) and tighten securely.
4.- Fit the vertical post (6) onto the
rear support (2), as shown in Fig.7.
Fit screws (109) along with the
washers (121) and tighten securely.
Make sure that the vertical post (6) is
vertical, Fig.7.
5.- Fit the main body (5) onto the main
support (1), as shown in Fig.7.
Fit screws (104)
washers (121) and nuts (126) and
tighten securely.
main support
along with the
6.- FITTING THE WEIGHTS.-
Fit the weight guide bars (35) into the
bottom casing bracket (4), Fig.8, fit
screws (109) along with the washers
(121) and tighten securely. Next, place it
on the main support (1), Fig.8, fit screws
(105) along with the washers (121) and
nuts (126) and tighten securely.
7.- Now fit the bottom washer for the
weights (32) and the bottom stop for
the weights (85), Fig.9.
Place the weights (51) onto the guide
bars as shown in Fig.9.
Fit them in alphabetical order with the
letters facing away from the machine,
starting with the letter "L".
8.- Now take the weight selector post
(50), Fig.9, and insert it onto the last
weight, fit the selector ring (53) onto
(1)
the central boss on the weight selector
post, as shown in Fig.10.
9.- ASSEMBLING THE TOP
SECTION.-
Place the top body (7), Fig.10, onto the
main body (5), inserting it onto the
vertical body (6), Fig.10.
Attach the vertical body (6), Fig.10,
using screws (107) along with the
washers (121) and nuts (126) and
tighten securely.
Now fit screws (106) for attaching the
top body (7) with the main body (5)
along with the washers (121) and nuts
(126) and tighten securely.
10.- Next, fit the top casing bracket
(10), first inserting it on the weight
guide bars (35) and then brining it up to
the top support (7), Fig.10.
Fit screws (109)
washers (121) and hand tighten.
31
along with the