Allen-Bradley PowerFlex 40 Guide De Mise En Route page 14

English-12
Integral Keypad
RUN
FWD
REV
PROGRAM
No. LED
Run/Direction
Status
Alphanumeric
Display
Displayed Units Steady Red
Program Status Steady Red
Fault Status
Pot Status
Start Key Status Steady Green
No. Key
(1)
IP66, NEMA/UL Type 4X rated drives are not equipped with a potentiometer.
VOLTS
AMPS
HERTZ
FAULT
LED State Description
Steady Red Indicates drive is running and commanded motor direction.
Flashing Red Drive has been commanded to change direction. Indicates
actual motor direction while decelerating to zero.
Steady Red Indicates parameter number, parameter value, or fault code.
Flashing Red Single digit flashing indicates that digit can be edited.
All digits flashing indicates a fault condition.
Indicates the units of the parameter value being displayed.
Indicates parameter value can be changed.
Flashing Red Indicates drive is faulted.
Steady Green Indicates potentiometer on Integral Keypad is active.
Indicates Start key on Integral Keypad is active.
The Reverse key is also active unless disabled by A095
[Reverse Disable].
Name Description
Escape Back one step in programming menu.
Cancel a change to a parameter value and exit Program
Mode.
Select Advance one step in programming menu.
Select a digit when viewing parameter value.
Up Arrow Scroll through groups and parameters.
Down Arrow Increase/decrease the value of a flashing digit.
Used to adjust internal frequency of IP66, NEMA/UL Type 4X
rated drives only when a Display Group parameter is shown
and P038 [Speed Reference] is set to internal frequency,
A069 [Internal Freq].
Enter Advance one step in programming menu.
Save a change to a parameter value.
(1)
Potentiometer Used to control speed of drive. Default is active.
Controlled by parameter P038 [Speed Reference].
Start Used to start the drive. Default is active.
Controlled by parameter P036 [Start Source].
Reverse Used to reverse direction of the drive. Default is active.
Controlled by parameters P036 [Start Source] and A095
[Reverse Disable].
Stop Used to stop the drive or clear a fault.
This key is always active.
Controlled by parameter P037 [Stop Mode].
Menu Description
Display Group (View Only)
Consists of commonly viewed drive operating
conditions.
Basic Program Group
Consists of most commonly used
programmable functions.
Advanced Program Group
Consists of remaining programmable functions.
Fault Designator
Consists of list of codes for specific fault
conditions. Displayed only when fault is present.
(1)