Using The Sd Card - Apex iCH Prime Instructions D'utilisation

iCH Prime/English
4.6 Using the heated humidifier
1. Turn the control knob on the back of the device to turn on the heater and the heater on
indicator
above the knob will light up (orange light), as shown in Figure 4-1
2. Adjust the control knob to increase the humidity in the range of 1 to 6 (see diagram). 1 is
minimum humidity, 6 is maximum humidity. The optimum setting is dependent on the ambient
temperature and humidity of your room.
NOTE: When the 'Low P' sign is displayed on the screen while large air leakage is
detected, heating will automatically stop with the heater indicator lights off. (e.g.
removing the mask will stop the machine from operating.) If the air leakage
problem is eliminated, heater will resume again.
Danger:

4.7 Using the SD card

If doctors need to review the usage data, they may ask you to use the SD card to copy data from
the device, and to return the card to them. Data that is copied to the SD Card is still stored and
available on the device.
1. Insert the SD Card when the device is in standby mode.
2. Data copying starts automatically when the SD Card is inserted into the slot.
3. The [COPY] & [Card] message is displayed on the LCD while data is being copied.
4. The [End] & [OK] message is displayed on the LCD when copying has finished.
5. Remove the SD Card and mail it to the clinician.
6. The SD Card should be stored in the plastic card case when not in use. The SD card
does not need to be uninstalled for the device to work properly.
CAUTION: Do not remove the SD card until [End] & [OK] message is displayed on the LCD,
or data copied to the card may be corrupted or missing.
Figure 4-1
In order to avoid the destruction or damage to the device or even the
hazard of electric shock, when the water chamber is attached, DO NOT fill
water from the outlet port of the water chamber. Users must fill water no
more than the maximum mark after the water chamber is removed from the
device.
14