SOMFY animeo Motor Controller 6 AC IB+ DRM Notice D'installation page 10

EN
Before installation, please read and follow these instructions. Incorrect installation may lead to serious
m
injury. Disconnect all power cables to be installed! Take precautions against unintentional switching on!
The product must be installed, maintained and dismounted by a skilled person according to the relevant reg-
ulation. An all-pole mains switch shall be incorporated in the electrical installation of the building to provide
simultaneous separation of at least 3 mm for all phases from the supply. SOMFY cannot accept any liability for
defects and damage caused by failure to follow these instructions. Please keep these instructions for future
reference.
m The individual motor cables must be protected electrically according to the current carrying capacity of the
cables used.
SOMFY hereby declares that this product is in compliance with the essential requirements and other
relevant provisions of the European Directives applicable to the European Union. A declaration of con-
formity is available at www.somfy.com/ce.
A
MOUNTING
[1] Needed space for the DIN-rail version
1. Mounted in a electrical cabinet
[2] DIN-rail mounted
1. Clip-on the device
2. Unclip the device
B
WIRING
[1] Wiring diagram
Two wires of identical diameter must be used in
order to daisy chain the IB+ bus cable.
[2] Check the correct running direction of the end
pro ducts.
UP: All end products move upward ()
STOP: All end products stop ()
DOWN: All end products move downward ()
n To close window press UP, to open window
press DOWN
[3] Possible switches
1. Smoove Origin IB, Ref. 1811272
2. Double push button unlocked
[4] Local control
One local push button can control motors on
several Motor Controller
C
CONFIGURATION
If configuration is not possible via Building Controller,
the settings can be made manually
[1] Mode
Local push button ergonomics and the type of
end products to be preselected:
·
Screen mode (SCR), without tilting
·
Venetian blind, European mode (EU) = default
mode:
Short press = tilt
Long press = run
10/32
- animeo . Motor Controller 6 AC IB+ DRM . Ref. 5151045C
·
Venetian blind, US mode (US):
Long press = tilt
Short press = run
1. Open settings
2. To toggle between modes, press shortly the
Reset/Prog button. Repeat until the LED,
according to the desired configuration, lights
up.
3. Save and exit
[2] Running time
Local control
1. Move screen to upper end limit
2. Press Stop until screen moves down on its
own
3. Press Stop when lower end limit is reached
[3] Intermediate position
1. Recording
2. Recalling
[4] Factory RESET
[5] Symbols: actions
1. Up
2. Down
3. Stop
[6] Symbols: end product status
1. Up movement
2. Down movement
3. Upper end limit
4. Lower end limit
5. Stop at the required position
6. Short up and down movement
7. Intermediate position (IP)
m When electronic motors are to be controlled
through this Motor Controller device it is
mandatory to configure the start-up delay time
for electronic motors in the Building Controller
settings.