Device Elements; Start Up; Operation - Kärcher NT 48/1 Mode D'emploi

Device elements

1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Drain hose
6 Suction hose
7 Suction head lock
8 Chassis
9 Dirt receptacle
10 Steering roller
11 Chassis handle
12 Floor nozzle
13 Suction tube
14 Suction support
15 Main switch
16 Suction head
17 Carrying handle
18 Cable hook
19 Bender
20 Cartridge filter
21 Fastening nut
22 Float
Dry vacuum cleaning
ATTENTION
Risk of damage! For dry vacuuming, the
cartridge filter must always be installed.
– To vacuum fine dust, you can also use
an additional paper filter bag.
Inserting the paper filter bag
Illustration
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
12

Start up

Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
– To suck wet dirt, first remove the paper
filter bag.
Installing an additional filter
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Loosen the mounting nuts
 Remove the cartridge filter.
Illustration
 Insert the fastening nut and tighten it.
 Install the additional filter.
 Insert and lock the suction head.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main
switch.
Emptying the dirt container
– The vacuum channel is equipped with a
float.
– When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
 Switch off the appliance at the main
switch.
Illustration
 Drain off dirty water through the drain-
age hose.
– 2
EN

Operation