Table des Matières
Publicité
12
GB
STEP NO. DESCRIPTION
19
Selection input 2
20
Minimum voltage input 2
21
Maximum voltage input 2
Conditions
22
switching input 2
Supply fan mode
23
switching input 2
Extract fan mode
24
switching input 2
25
Geo heat exchanger
Minimum temperature
geo heat exchanger
26
(Below this temperature
the valve opens.)
Maximum temperature
geo heat exchanger
27
(Above this temperature
the valve opens.)
STEP NO. DESCRIPTION
28
RH-sensor
Sensitivity
29
RH-sensor
Modifications reserved
Ubbink continuously strives after improvement of products and reserves the right to change the specifications
without prior notice.
78
Instelwaarden/ Setting values/ Einstellwerte
FACTORY SETTING
ADJUSTING RANGE
Ubiflux F150 PLUS
0 (= normally open contact)
1 (= 0 - 10V input active)
2 (= normally closed contact)
1
3 (= input 2/ bypas open 12V;
4 (= input 2/ bypas open 0V;
0,0 V
0,0 Volt - 10,0 Volt
10,0 V
0,0 Volt- 10,0 Volt
0 (= Off)
1 (= On)
0
2 (= On if conditions bypass open satisfied)
3 (= Bypass control)
4 (= Bedroom valve)
0 (= Input fan off)
1 (= Absolute min. flow rate 30 m
2 (= Flow rate mode 1)
3 (= Flow rate mode 2)
5
4 (= Flow rate mode 3)
5 (= Multiple switch)
6 (= Maximum flow rate)
7 (= No input fan activation)
0 (= Extract fan off)
1 (= Absolute min. flow rate 50m
2 (= Flow rate mode 1)
3 (= Flow rate mode 2)
5
4 (= Flow rate mode 3)
5 (= Multiple switch)
6 (= Maximum flow rate)
7 (= No extract fan activation)
OFF (= Valve control geo heat
OFF
ON (= Valve control geo heat
5,0 °C
0,0 °C - 10,0 °C
25,0 °C
15,0 °C - 40,0 °C
FACTORY SETTING
ADJUSTING RANGE
Ubiflux F150
OFF (= RH-sensor not active)
OFF
ON (= RH-sensor active)
+2 most sensitive
+1
0
0 default setting RH-sensor
-1
-2 least sensitive
Ubiflux F150 / F150+
Valeurs de réglage
bypass closed 0V)
bypass closed 12V)
exchanger off)
exchanger on)
↑
↓
STEP
0,5 V
0,5 V
/h)
3
/h)
3
0,5 °C
0,5 °C
STEP
Publicité
Table des Matières
