Publicité
CDI MAGNETO
2. Install:
• Woodruff key 1
• Rotor 2
NOTE:
• Clean the tapered portions of the crankshaft
and rotor.
• When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
• When installing the rotor, align the keyway c
of the rotor with the woodruff key.
3. Install:
• Plain washer
• Nut (rotor) 1
4. Connect:
• CDI magneto lead
Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
5. Install:
• Dowel pin
• O-ring
New
• Gasket [crankcase cover (left)]
• Crankcase cover (left) 1
• Hose holder (cylinder head breather
hose) 2
• Bolt [crankcase cover (left)]
NOTE:
• Apply the lithium soap base grease on the O-
ring.
• Tighten the bolts in stage, using a crisscross
pattern.
4 - 80
ENG
56 Nm (5.6 m · kg, 40 ft · lb)
New
10 Nm (1.0 m · kg, 7.2 ft · lb)
Publicité
Chapitres
