4
Operation
The programmed function (see 4.1) is activated with the button (Fig. 2 C).
The LED (Fig. 2 B) shows the current status of the control unit.
All functions:
GREEN: output is active
ORANGE fl ashing: if the ENABLE function is activated, but there is no voltage at the ENABLE input, the LED
status fl ashes orange. When voltage is applied at the ENABLE input, the LED goes out.
Timer B:
The red LED is permanently on during the pausing time. The LED starts to fl ash towards the end of the pausing
time.
Set pausing time:
•
>= 70 Sec.
from Sec. 60 → slow fl ashing
from Sec. 40 → moderate fl ashing
from Sec. 20 → quick fl ashing
•
>=10; <70 Sec.
9 → slow
6 → moderate
3 → quick
•
>= 5; < 10
4 → moderate
2 → quick
•
< 5
1 quick
5
Customer service
Please write down the address of your customer service here:
......................................................................................................................................................
......................................................................................................................................................
.......................................................................................................................................................
.....................................................................................................................................................
......................................................................................................................................................
WE DO IT FIRST.
Installation and usage instructions
sentiotec GmbH
world of wellness
Oberregauer Straße 48
A-4844 Regau
T: +43 (0) 7672 27720-567
F: +43 (0) 7672 27720-801
E-Mail: support@sentiotec.com
www.sentiotec.com
p. 7/10
EN