Control Panel - Weston HARVEST GUARD 65-1101-W Manuel D'instructions

WARNING!
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
. Power Light: The Power Light will remain illuminated when the Vacuum
Sealer is connected to the power supply.
. On/Off Button: The On/Off Button turns the unit on or off when connected to
the power supply.
. Start Button: The Start Button starts the Vacuum Pump, which engages the
air evacuation process.
. Seal Button: This button will start the Seal Bar at any time. ONLY push this
button while the Vacuum Pump is running.
. Pulse Button: The Pulse Button can be used when vacuum sealing delicate
items or liquids, allowing the vacuum process to be controlled. Once a bag is set up
to vacuum seal, press the Pulse Button once to lock the bag. Then press the Pulse
Button as much or as little as desired until the desired amount of air is removed.
Press the Seal Button to seal the bag.
. Accessory Button: Press the Accessory Button when using any external
accessories, via the Vacuum Hose Port.
. Seal Window:
seconds that the Sealing Bar will be activated to apply heat to the bag that creates
the seal. Once the Seal Bar is activated, the display will countdown to "0". See the
"Bag Sealing" section in this booklet for further information on sealing vacuum bags.
. Seal Time + and - Buttons: The Seal Time Button adjusts the number
of seconds that the Sealing Bar will apply heat to create the bag's seal. The
optimal time for different brands of bags can be adjusted using the Plus (+) or Minus
(-) Buttons. See the "Bag Sealing" section in this booklet for further information on
sealing vacuum bags.
NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags with an embossed or mesh lining.
DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other
than the uses described in this booklet, could potentially damage the appliance and void
the warranty!
Before cleaning, assembling or disassembling the

CONTROL PANEL

The numeric LED Seal Window indicates the number of
-8-
Figure 4