Outlet Instructions - Weston HARVEST GUARD 65-1101-W Manuel D'instructions

DO NOT USE BOTH POWER CORDS AT THE SAME TIME!
This appliance has a polarized plug (one blade of
the plug is wider than the other blade) (Figure 4).
To reduce the risk of electrical shock, this plug must
fit fully into the outlet. If the blades do not fit into
the outlet, try turning the plug around. If the plug
still does not fit into the outlet, contact a qualified
electrician. DO NOT attempt to modify the plug in
any way.
Plug the Vacuum Sealer into a standard 120 Volt,
60 Hz wall outlet. Avoid using extension cords.
ALWAYS DISCONNECT Vacuum Sealer from
power source when not in use.
This unit includes an alternate 12 Volt Adapter
Power Cord (Figure 3a). The 12 Volt Adapter
Power Cord can be used to power the Vacuum
Sealer on the go.
Plug the 12 Volt Adapter Power Cord plug
1.
end into the side of the Vacuum Sealer (Figure 3b).
2. Plug the 12 Volt Adapter Power Cord port
plug end into the 12 volt plug inside a boat or car.
WARNING!: DO NOT use the Vacuum Sealer
outdoors. TO PROTECT AGAINST RISK OF
ELECTRICAL SHOCK: DO NOT SUBMERGE OR
USE THE VACUUM SEALER IN OR AROUND
WATER OR LIQUID. DO NOT use this appliance
while driving or boating!

OUTLET INSTRUCTIONS

-6-
-7-
Port Plug
Figure 3
Figure 3a
Plug
Figure 3b
12 Volt
Power
Cord
Port