Vacuum Operation - Weston HARVEST GUARD 65-1101-W Manuel D'instructions

WARNING!
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
BEFORE ATTEMPTING VACUUM PACKAGING BE SURE THAT THE
VACUUM SEALER IS SET UP IN ACCORDANCE WITH ALL OF THE SAFETY
PRECAUTIONS LISTED IN THIS BOOKLET.
Open the Vacuum Lid, press and
1.
unlock both corners by pressing down on the
two grey corner panels on the Vacuum Lid.
2. Place the items to be vacuum sealed
into a vacuum bag. Allow at least 2" (5 cm)
at the open end of the bag in order to create
enough seal space. Be sure not to cover the
Vacuum Port (Figure 5).
Close the Vacuum Lid, press and lock
3.
both corners by pressing down on the two
grey corner panels on the Vacuum Lid.
4. Check that the bag opening is in the
center of the Vacuum Chamber.
5. Press and release the Start Button.
The Vacuum Pump will begin removing
air from the bag while the LED Vacuum
Window begins to count up. The LED
Vacuum Window will count up starting at
the number "1" and going thru to the number
"9", before automatically engaging the bag
sealing process. These numbers represent
stages, not seconds.
6. Once the LED Vacuum Window displays the number "9", the sealing process
will begin by counting down from your chosen setting to "0" on the LED Seal
Window.
7. Once the LED Seal Window has reached "0", the Vacuum Sealer will
automatically stop the Vacuum Pump and release the vacuum pressure moments
later. DO NOT ATTEMPT TO PULL THE VACUUM LID OPEN BEFORE THE
VACUUM HAS BEEN RELEASED, SEVERE DAMAGE TO THE SEALING BAR
WILL RESULT.
8. Open the Vacuum Lid, press and unlock both corners by pressing down on
the two grey corner panels on the Vacuum Lid.
NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags with an embossed or mesh lining.
DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other
than the uses described in this booklet, could potentially damage the appliance and void
the warranty!
Before cleaning, assembling or disassembling the

VACUUM OPERATION

Vacuum
Port
-11-
Figure 5
Leave 2"
Seal
Space