Request Vehicle Information - Obd-Ii - tecnotest EZ-SCAN 4000 Manuel D'utilisation

__________________________________________________________________________ EZ-SCAN 4000
4.4 -

Request vehicle information - OBD-II

•
Before scanning a vehicle, the EZ-Scan 4000 scanner must be correctly configured
for your vehicle. Refer to "Setup /Operating Instructions" on chapter 2.0 if you
need to configure the scanner.
•
Press the POWER key to display the EZ-Scan 4000 scanner opening screen.
•
Press the MON key to display the Monitor menu. Use the arrow keys until
5 - Vehicle Indent or 5 - System Info is highlighted, then press ENTER.
•
The Vehicle Information will be displayed, such as (VIN_) Vehicle Identification
Number and (CVN) Calibration Verification Number. The IDs can be displayed in
Hex values and/or in Mnemonic. Not all Info types are applicable or supported by
all systems. There can be multiple Calibration IDs from multiple (ECUs) Electronic
Control Units, i.e., ECM, TCM, or PCM etc., depending on what your Vehicle
supports and the protocol the ECUs use.
Example:
ID# $00, $01
CVN. 0013564
This example shows an ID#, the vehicles ECU's ID. This information must be supplied
on 2003 and newer vehicles in order to identify VIN's, CVN's, and certain ECU ID's. Use
the arrow keys to select more Data items if available.
•
Press the MON key to return to the opening screen.
NOTE:
If Vehicle does not support this menu item then, "Not Valid Perform Scan" appears
on the display or defaults back to MON main menu. Rescanning the vehicle will not
change this message if you have already performed a scan, the vehicle does not
support this menu item.
OPERATING INSTRUCTIONS
VIN. MRYN47NH1D65439
MRYN65439

51